PT1000 Pro ¼¹Ì½ºÅÍ M3/M4 * ¸ðµç Á¤º¸´Â PT1000 Á¤º¸¸¦ ÂüÁ¶ÇÒ ¼ö ÀÖ½À´Ï´Ù: Trianglab ¼¹Ì½ºÅÍ Ä«Æ®¸®Áö PT1000 ÃÖ´ë 450 µµ.
?Name:
PT1000 Pro Thermistor M3/M4
?Marlin Firmware Configuration:
Connect directly to the thermal interface of the control board and then determine which one to choose according to the pull-up resistor of the interface. In most cases it is 4.7K ohms, please check your motherboard manual for details.
* 1010 : Pt1000 with 1k¥Ø pullup
* 1022 : Pt1000 with 2.2k¥Ø pullup
* 1047 : Pt1000 with 4.7k¥Ø pullup
?Klipper documentation:
Directly connected PT1000 sensor. The following parameters are available in heater sections that use one of these sensors.
sensor_type: PT1000
sensor_pin:
# Analog input pin connected to the sensor. This parameter must be
# provided.
#pullup_resistor: 4700
# The resistance (in ohms) of the pullup attached to the sensor. The
# default is 4700 ohms.
?Durt 3D:
https://docs.duet3d.com/en/User_manual/Connecting_hardware/Temperature_connecting_thermistors_PT1000
?More information:
?Description:
PT1000 sensors are able to measure higher temperatures than thermistors - upto 400°C,and are more accurate then both thermistors and thermocouples in general.
PT1000 sensors can direct replace the thermistors in your printer without adding an amplifier board like PT100`s sensors.
but whith the default 4.7K pullup resister on board you will get lower resolution than other sensors.
PT1000 sensors are compatible with most firmwares in the field.
PT1000 sensors are potentially a good cost and performance compromise between thermistors and PT100 sensors.
If you want release potential abilities of the PT1000 sensors,you need to replace the 4.7Kpullup resister of the thermistor pins with a 1K 0.1% resister.
continuous 500 degree Celsius Guaranteed
?Technical Information:
?Display: