Switch Technical Data £º
Power supply: Self-powered£¬without extra power supply
Key Type: on/off or toggle, depends on switch type
Life Time: >100 000 cycles
Condition: -20°~60°
Installation and Operation
Attention:
It cannot be fixed in metal box, near or on the ground and near a big block of metal. Otherwise, it¡¯s difficult for the receiver to receive the radio signal.
Package Include:
1 X Wireless Receiver
1 X Remote Control ( Self-powered, No need battery inside, environmental protection)
2 X Instructions
1 X gummed paper
![1](https://ae01.alicdn.com/kf/HTB1biXgXzzuK1RjSsppq6xz0XXaw.jpg)
![2](https://ae01.alicdn.com/kf/HTB15epfXzvuK1Rjy0Faq6x2aVXag.jpg)
![3](https://ae01.alicdn.com/kf/HTB1z04fXELrK1Rjy1zbq6AenFXas.jpg)
Specifications(Technical Index):
Model: KR2201-4
Product Type: Single Channel Remote Control Switch
Encoding Type: Intelligent Learning Code
RF Working Mode: Superheterodyne Reception
Modulation Mode:ASK
RF Frequency: 433MHz
Working Mode:Momentary, Toggle and Latching
Input Voltage: AC 85V~250V
Quiescent Current: 5mA
Receiving Sensitivity: >97dbm
Remote Control Range: >50m (Free Space)
Wired Connection Way: Fixed Wiring Pillar
Output Terminal: NO,COM,NC
NO: Normal Open(Output).
COM:Common(Output).
NC: Normal Close(Output).
Color: Green(PCB Board), Black (Outside Shell)
Circuit Board Size: 6.5 * 3.2 * 1.6cm/ 2.5 * 1.25 * 0.62in
Circuit Board Weight:20g / 0.7oz
Package Size:8.1 * 3.6 * 2.0cm / 3.1 * 1.2 * 0.78in
Package Weight: 36g/1.26oz
Operation Introduction:
About Working Mode:
Toggle: Press once the remote button, the relay connects, press the remote button twice, the relay disconnects.
Clearing the Code:
Press the Learning Button on the receivers for 8 times, the codes will be cleaned.
After cleaning the code, all the remote control cannot work any more.
Learning the Code: (Toggle)
Press the learning key on the receiver Four time, it comes into toggle setting mode.
Wait for a moment, the LED will be off , it comes into learning state.
Press the remote button, LED indicator on the receiver board will flash then come off.
After 3 seconds, the LED indicator will be on again, learning successfully..
/piece
/set
/set
/piece
/set
/piece
/piece
/set