BLV PT1000 ÇÁ·Î ¼¹Ì½ºÅÍ Ä«Æ®¸®Áö 3D ÇÁ¸°ÅÍ ¿ë °í¿Â 450C È»ê v6 È£¿£µå ¶óÇǵµ µå·¡°ï PEI ź¼Ò ¼¶À¯
PT1000 PRO *All information can refer to PT1000 information£ºBLV Thermistor Cartridge PT1000 Upto 450 degrees.*Compatible V6 Heater Block(NEW)*Compatible Volcano Heater Block*Compatible DRAGONfly/dragon HOTEND*PT1000 sensor is not compatible with Lerdge K motherboard
BLV Thermistor Cartridge PT1000 Upto 450 degrees.
*Compatible V6 Heater Block(NEW)
*Compatible Volcano Heater Block
*PT1000 sensor is not compatible with Lerdge K motherboard
?Technical Details:
Thermistor Specifications:
?Marlin Firmware Configuration:
Connect directly to the thermal interface of the control board and then determine which one to choose according to the pull-up resistor of the interface. In most cases it is 4.7K ohms, please check your motherboard manual for details.
* 1010 : Pt1000 with 1k¥Ø pullup
* 1022 : Pt1000 with 2.2k¥Ø pullup
* 1047 : Pt1000 with 4.7k¥Ø pullup
?Klipper documentation:
Directly connected PT1000 sensor. The following parameters are available in heater sections that use one of these sensors.
sensor_type: PT1000
sensor_pin:
# Analog input pin connected to the sensor. This parameter must be
# provided.
#pullup_resistor: 4700
# The resistance (in ohms) of the pullup attached to the sensor. The
# default is 4700 ohms.
?Durt 3D:
https://docs.duet3d.com/en/User_manual/Connecting_hardware/Temperature_connecting_thermistors_PT1000
?More information:
SET001
SET002