Honor50 Full Glue UV Tempered glass for Huawei Honor 50 Pro screen protector for honor 50 honour 50 Protective glass UV Light
installation steps:
1. Wipe the phone with the film cleaning bag until it is clean and satisfactory.
2. Cover the earpiece hole and button hole with a label.
3. Drop the nano glue on the screen that is flat and clean and dust-free. Use each glue as appropriate. Wipe off the excess glue before turning on the light.
4. Tear off the release film on the protective film, then align one end of the film on the label, make the glass contact the glue, and slowly put down the film (if there are air bubbles during this process, lift and replay until there are no air bubbles)
5. Wait for about 30 seconds, let the glue slowly spread and level
6. Wipe off the spilled glue with a dust-free cloth. After the retention standard of the tempered film, the light goes back and forth around the edge of the phone 3 times, (not in the middle) after initial curing for 3 seconds, then wipe off the edge glue until the overflowing glue no more
7. Wait for the exhaust to be completed, after the glue overflow is cleaned up, and the positioning standard of the tempered film is satisfied, and the light is turned on, otherwise the material will be scrapped.
8. To irradiate the mobile phone under the UV light, it needs to be irradiated up and down twice for about 60 seconds to reach the fully cured position.
Special Note:
It is best to finish the film and turn on the light as soon as possible. After a long time, the nano-glue will solidify when it sees the ultraviolet rays of the sun. On the other hand, the glue will run to the lower part of the two sides. The white border is the reason for this.
1. The exhaust is slow, and the overflow of glue is normal.
2. Do not press the film with your hands during the exhaust process, there will be bubbles when you press 100% by hand.
3. The exhaust is not finished in the small corner, you can fill in the glue. It is recommended to raise the other side to run glue. 4. Do not expose indoor stickers to sunlight, there is a lot of ultraviolet rays in the sun.
5. First check whether the light is on.
6. Before turning on the light, clean up the spilled glue.
7. After turning on the light and prying it open, the tempered film will be scrapped.