Introduction of the new zonal hot bed
Advantage 1: This hot bed uses zoning heating without the need for motherboard support, and the hot bed can also achieve 125*125mm middle range zoning heating. It can be used in more than 90% of ENDER-3 series models on the market.
Advantage 2: The heating time is 20% faster than the ordinary hot bed.
Advantage 3: When the printing model range in the middle of 125*125mm range in the hot bed there is a partition switch to turn him off theoretically can achieve power savings of 70%, measured 24 hours can save 0.5 kW·h of electricity, to achieve energy saving.
Advantage 4: the new zoning hot bed using a new spraying technology, black spraying than gold PEI better adhesion, printing PLA temperature at the same time in the case of 60¡É, adhesion than gold PEI better than 20%.
Advantage 5:The new PEI spraying comes with partition indication range, which is a perfect solution to the problem of easy to fall off than the printing on the market with our new black PEI.
Advantage 6:The new partitioned heat bed adopts the middle heat insulation slot to make the middle 125*125mm range of temperature conduction to the side more slowly thus solving the unnecessary heat loss.
Note: Positive and negative wiring should not be reversed. Reverse connection will cause the power indicator does not light up, but the function of normal use.
This hot bed print size is 235mx235mm. Fixed leveling hole position is 170mX170m
Hot bed is designed with 24v voltage, the most power is 240W and the least power is 100W (partition function).
When using the hot bed, the printer needs at least 24V300W power supply for the whole machine. In theory can perfectly replace and support all printing area 235mnX235mm fixed holes for 170mX170m printers..
Support models: Creality ENDER-3 series, Elegoo Neptune 3 pro, Anycubic Kobra, BIQU-B1, BIQU Hurakan, SUNLU T3, KINGROON KP5M, Two Trees BLU-3, and other 3D printers.
Weight:
Hot Bed 600g
Hot Bed+PEI 1200g