Passive POE injector 8 port black 10/100 Mbps Power over Ethernet PoE patch panel for IP Camera, VOIP, WiFi AP
This poe injector without the power supply. The power supply is sold seperately.
FEATURES
1. With POE and LAN port
2. With 2.1*5.5mm DC Female dock
3. Pin4/5 positiv, Pin7/8 passive
4. CE/ROSH certificate
5.Use with any ethernet switch
6.Flexible power(DC 12V TO 56V)
7.10/100Mbps fast ethernet
8.Ideal for IP Cameras,VOIP,WiFi
9.8 Port Injector(8 Lan&8 Lan+PoE port)
SPECIFICATIONS
Input | 12-56V DC 2.1MM |
Output | 12-56V PER PORT(30W Max) |
Data | 1/2&3/6 |
Power | 4/5 V+ & 7/8 V |
Data In | Connects PC/HUB/Switch |
Weight | 140g |
Dimensions | 175mm×37mm×20mm |
Ethernet Cable | TIA/EIA 568 Cat. 5 |
Data rate | 10/100Mbps |
Connector | RJ-45 |
Operating Temperature | 0°C ~ 40°C |
Storage Temperature | -40°C~+70°C |
Operating Humidity | 10%~80%RH |
Storage Humidity | 5%~90%RH |
Certification | CE , FCC |
1.Panel 8 integrating passive POE injector suitable for powering up to eight devices.
2.The RJ45 connectors on one side are connected Ethernet ports with no power (switch)
on the opposite side of the device used to connect power for Ethernet cable.
3.Are used to power the two unused pairs of the Ethernet cable.
4.Power couples: 4,5 (positive pole) / 7,8 (negative pole)
LOW COST SOLUTION FOR PoE
We have POE patch panel& injector which can power most 802.3af/at PD device with 48V power supply.
(such as IP camera, IP phone, WiFi access point AP, iPad and Tablet etc.)
1. Solution for POE device:
poe injector + 48V power supply(Midspan) and non-poe switch it is same as most of your POE switch (Endspan)
2. Solution for Non-PoE device
PoE injector +48V power supply+ 5v2a or 12v1a poe splitter for these device which don\'t Support POE(802.3af/at).
LED INDICATOR
POWER LED
POWER OFF --Off 4/5 (V+),7/8 (V-)--Green 4/5 (V-),7/8 (V+)-- Rad
HOW TO INSTALLATION YOUR PoE
step 1 Select switch or injector by number of devices and data rate.
Step 2 Select power supply by PoE standard and power consumption.
Step 3 Plug DC power supply into DC input(use Mode A on Dual Mode Injectors)
Step 4 Plug DC power supply into AC power outlet.
Step 5 Connect Ethernet jumper from data source to LAN port on your PoE injector.
Step 6 Connect Ethernet cable from device to the PoE port on your PoE injector.
Tips:
1. The installation site must be away from heat source and electromagnetism interference source,
non-corrosive gas and metal dust.
2. Must not block the cooling hole of the equipment.
3. Installation must be stable fixed placing, not a violent shock.
4. Prevent to crash and conflict with other equipment during the installation, so as not to cause
Local damage of the machine surface.
5. When storing, must be kept in dry warehouse, not exposure to sun and rain.